How do you use a spi programmer to fix bios on motherboard
- HOW DO YOU USE A SPI PROGRAMMER TO FIX BIOS ON MOTHERBOARD HOW TO
- HOW DO YOU USE A SPI PROGRAMMER TO FIX BIOS ON MOTHERBOARD INSTALL
(BEFORE BOOTING MAKE SURE PARALLEL PORT IS SET TO LPT/378h IN BIOS!) Once you have everything hooked up and triple checked (don’t forget to hook up port 1 to +3V and 2 (that is also connected to 18 on the LPT) to 0V), then it’s time to shut down your laptop/desktop that you wish to flash from and change the BIOS to boot from CD, restart again and boot into the CD.
Once you have created the flashing cable then it is time to plug it into the Serial Port on your chosen flashing computer (Make sure it’s mode is set to LPT port as detailed in the pdf, check and recheck these!) The ports should be as so: LPT Port The guide to creating this cable is detailed here ↗, note it is VERY important to use the 3V line from the spare PSU (to hot-wire the spare PSU use the paperclip and make a connection between the green wire and ANY black wire) and NOT 2x AA batteries as 2x AA’s will not work (believe me I’ve tried), also ignore the bootable USB as were using a CD. take off the outer sleeving so all you are left with is the header that will connect to the SPI Port and about 1M of wires. iso, SPIPGM (Used to flash the ROM), CWSDPMI7 (DPMI host process needed by SPIPGM)).īurn the Universal Boot to a CD, place both SPIPGM and CWSDPMI7’s /bin files as well as the BIOS ROM in the C: directory on your laptop/desktop that you will be doing the flashing from.
HOW DO YOU USE A SPI PROGRAMMER TO FIX BIOS ON MOTHERBOARD HOW TO
HOW DO YOU USE A SPI PROGRAMMER TO FIX BIOS ON MOTHERBOARD INSTALL
The board is spotless, absolutely perfect, all the lights come on and even when you install the GPU wrong the little warning light comes on but it will not POST, just says CPU INIT all the time and restarts every 3/4 seconds as if there was a bad overclock and it was resetting to default.Īs you can see something was obviously up with it and as it wouldn’t even POST i couldn’t flash the BIOS. Got a Blitz formula today and i thought all was well plugged in the 24pin ATX and EATX power and all the lights were on (good stuff) Clicked the on button, the LCD was stuck with CPU INIT, I’ve tried clearing CMOS everything I don’t know what the hell is wrong, currently in the process of resetting the CMOS (press CLR_CMOS button and take out the battery for 2 hours). So this was me when i first got the motherboard: